Page 1 of 1 1
Topic Options
#1568932 - 04/12/18 11:16 PM 2480 Jog wheel removal help
keeppracticing Online   content
Planeteer


Registered: 07/13/12
Posts: 1114
Loc: Atlanta
The two concentric jog wheel plastic caps on the 2480 appear to be a bit harder than the single one on the 2000 to remove from the spindle pot. I need to replace the board it sits on. Is there a trick, or just use a little force to remove it? There's no clip, trick or similar that needs to be released? I looked at the Service Manual but only a detached cap was displayed on the exploded view, so not really helpful.

Any ideas???

Top
#1569409 - 04/18/18 07:21 PM Re: 2480 Jog wheel removal help [Re: keeppracticing]
blair Offline
Planeteer


Registered: 04/06/13
Posts: 40
grab a small putty knife and slip it in under and pry away.
Top
Page 1 of 1 1


Hop to:
Shout Box

Who's Online
5 registered (keeppracticing, Xenophile, 3 invisible) and 63 anonymous users online.
Top Posters
49172
Jazzooo
43828
Al
40001
Silversmith
38286
Timster
32942
Tom Mix
28710
NOK
27023
gonzo
26882
Popmann
26732
Ismellelephant
25647
Doughboy
25087
Mooseboy
24819
moontan
23691
paulb
23477
flatcat
23068
RGR
21908
Marty Gilman
21125
fonts
21061
C Jo Go
20078
Gretsch 6120
19722
fabulousthunderbird
19598
vvvm
19386
String Jammer
18985
glensimonds
18937
Vanillagrits
18923
T57Strat
18894
GAMBLE
18791
Jammer
17680
SteveW
17600
GAWZDigitalUnderground
17522
Geo
17271
Hano
16363
JazAddict
16175
Delso
15818
LakeStone Karl
15074
Liquidirt
14974
Dave Morris
14958
virtualan
14908
kid-surf
14844
Dan Barnes
Forum Stats
20700 Members
30 Forums
132886 Topics
1529920 Posts

Max Online: 226 @ 03/21/16 07:30 AM
Newest Members
BlueAsher, riddick789, tbirdmike, BradVS, Emil
20700 Registered Users

Generated in 0.042 seconds in which 0.039 seconds were spent on a total of 13 queries. Zlib compression disabled.