Page 3 of 3 <123
Topic Options
#1545244 - 09/21/17 05:57 PM Re: Copying from VS-1880 IDE drives to PC [Re: jerry1d]
jerry1d Offline
Planeteer


Registered: 02/17/10
Posts: 142
@ Minnisotan

"I would be willing to host it for you and make the link available on this forum"

Is there any link for the program and it's instructions yet?

Top
#1557888 - 01/15/18 07:49 PM Re: Copying from VS-1880 IDE drives to PC [Re: jerry1d]
Minnesotan Offline
Space Cadet


Registered: 09/02/17
Posts: 9
To all concerned, I offer my most sincere apologies... within 24 hours of my last post, I had a medical emergency, was hospitalized for several weeks, had two surgeries, and have had a tough time recovering. I'll be 70 this year, and these old bones aren't recuperating like they used to \:\(

If anyone wants the program and instructions, please PM me with your e-mail and I'll gladly send them to you.

I am just now trying to get back into this project, but it's slow going. The hard drive in my 1680 is dead, and so I'm trying to get the CF card conversion to work, but not having much luck thus far. I can only work on it in short spurts, though, and then I "run out of gas". Very frustrating.

Once again, my sincere apologies to all concerned.

Blessings...

Top
Page 3 of 3 <123


Hop to:
Newest Members
raultv, Bgdlive59, AncientJuan, jairo santos, drshum
21372 Registered Users

Generated in 0.057 seconds in which 0.004 seconds were spent on a total of 13 queries. Zlib compression disabled.